Error Signal; Operational Notes - Emtec Photo Cube Photo Cube 160GB User Manual

10. Error Signal :

1) The data or the flash card may have been damaged when the error icon
flash card or replace it.
2) If the unit is hanging for incorrect operations, please press the [Reset] button on the right side of the unit
to shut it down.
3) In USB mode, if the unit's power is too low, icon
down and connect with a DC power adapter. Then turn on the unit and continue your work.

11. Operational Notes :

1) If the unit can not be recognized by computer in USB mode, or the unit can not recognize the built-in
harddisk, please pay attention to these:
•Is there any problem of the installation of harddisk?
•This unit only supports FAT32 format. Under WINDOWS 2000/XP system, the built-in harddisk can
not be recognized if the memory size of partition is more than 32GB.
2) Install the harddisk carefully to keep from damage.
3) To keep the efficiency of the unit, it is suggested to do disk defragmenter periodically.
4) The built-in harddisk must be FAT32 format.
5) Carefully insert and remove flash cards.
6) Do not give shock or collision on the unit when the data is transferring.
7) Do not remove the cover of the unit because it is easy to damage the circuitry.
8) Do not leave the unit in a location subject to water or a humid environment.
9) Use DC power adapter when the unit is connected to the computer on work.
10) Back up and clean up the data within the harddisk at time to keep enough memory for copy.
will appear. Please press [Reset] button to shut it
appears. Please format the
P13