Programming The Softener - Morton M45C Installation And Operation Manual

Programming the Water Softener
RECHARGE
Clean Reminder
The screen in Figure 17 appears, with "CLEAn" flash-
ing in the display, when four months have elapsed on
the system's timer since start up or the last reset.
This is a reminder to use Morton
Softener Cleanser three times a year. To reset the
timer, press any button on the control panel and
"CLEAn" will disappear.
14
Display
button
FIG. 17
MWSC Water
®
Morton Water Softener Installation & Operation Manual
®
UP button
DOWN
button
SELECT
button
CONNECTION
STATUS light
Program the Softener
When the power supply is plugged into the electrical
outlet, the model code (o45) and a software version
number (example: r4.1), are briefly shown in the face-
plate display. Then the words "SET TIME" appear
and "12:00 PM" begins to flash.
NOTE: If "- - - -" shows in the display, press the
q
UP or DOWN button until the model code
shows in the display. Then, press the
SELECT button to set, and change to the
flashing "SET TIME" display.
Step 1. Set Time of Day
If the words "SET TIME" do not show in the display,
press the SELECT button several times until they do.
FIG. 16
FIG. 18
FIG. 19
continued on next page