Connecting The System To Wi-Fi - Morton M45C Installation And Operation Manual

Connecting the System to Wi-Fi

Step 1. Download the iQua™ App
Go to the App Store or Google Play and download
the iQua™ app. This must be installed on your
phone to set up an account and connect your water
softener to the "cloud".
Step 2. Set Up Your Account
1. Activate the iQua™ app.
2. On the welcome screen, click Create an Account.
FIG. 28
3. Fill in the required fields with your information
(name, phone number, address, etc.). Enter the e-
mail address you want to receive notifications.
Create a password to access your account.
4. Agree to the terms and press Complete.
5. A message to check
your e-mail appears.
An activation e-mail
has been sent to the
address you provided
when creating the
account. If you don't
see it your inbox,
check your spam or
junk folders, and flag it
as safe so that future
notifications from
myiqua.com will not be
blocked. Wait to click
the link in this e-mail
until you have put the
water softener control
into Connect Mode, as
follows.
FIG. 29
Check your email to activate your
account
FIG. 30
Morton Water Softener Installation & Operation Manual
®
Step 3. Put Water Softener Control
into Connect Mode
1. If you haven't already done so, program the water
softener with time, hardness, salt level, etc., as
shown on pages 14-16.
2. Make sure that the softener's display shows the
current time, without the word "SET". Press the
SELECT button several times if "SET" shows.
3. On the water softener's front panel (see Fig. 31),
press both the UP and
hold them for 3 seconds.
CONNECTION STATUS
light (see table below)
4. Release the buttons when "Conn" appears in the
display (See Fig. 31) and the connection status
light begins flashing amber.
5. The system is now in Connect Mode, ready to be
connected to the "cloud", and will remain for 15
minutes. If Connect Mode has "timed out" and the
light is off, you can enter Connect Mode again by
pressing both the UP and
holding them for 3 seconds.
Connection Status
light indication
System is in Connect Mode,
Flashing Amber
waiting to be connected to the
(for up to 15 min-
"cloud" via the home's wireless
utes)
router.
System successfully connected
Green
to the "cloud" and registered.
System is currently receiving
Red
an over-the-air update.
System not currently connected
No light
to the "cloud".
6. With the system in the Connect Mode, follow the
instructions on the next page to use the app to
connect your water softener to the "cloud" via the
home's wireless router.
q
DOWN buttons, and
Press both
UP and
DOWN
buttons,
and hold for
3 seconds,
to put into
Connect Mode
FIG. 31
q
DOWN buttons and
Status
17