Programming The Morton Water Softener - Morton MSD45E Install And Operation Manual

PROGRAMMING THE MORTON WATER SOFTENER

display
ELECTRONIC CONTROL SETTINGS REQUIRED
"
age (see Program Memory, page 18).
NOTES:
D WHEN THE POWER SUPPLY IS PLUGGED INTO THE ELECTRICAL OUTLET (STEP 10, PAGE 11),
12:00PM (flashing), and PRESENT TIME show in the upper display area. Program the electronic control as
follows. If A - - - is flashing, please see Model Code setting on page 20.
D A ''beeper'' sounds while pressing buttons for electronic control programming. One beep signals a change
in the display. Repeated beeps means the electronic control will not accept a change from the button you have
pressed, and you should use another.
D To program the electronic control, you will use either the SELECT, UP or DOWN buttons.
SET PRESENT TIME OF DAY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
"
NOTE: If the words PRESENT TIME do not show in the display, press the SELECT button until they do.
1.
Press either the SELECT, UP or DOWN button
to set. The UP button moves the display ahead;
the DOWN button moves the time backward.
NOTE: Each press of the UP or DOWN button
changes the time by one minute. Holding the but-
tons in changes the time 32 minutes each second.
2.
When the present time shows, press SELECT
to apply.
12
Mortonr Water Softener Installation & Operation Manual
DATA button
...
upon installation, and after an extended power out-
If the present time is between
noon and midnight, be sure PM
shows.
If the present time is between
midnight and noon, be sure AM
shows.
RECHARGE button
up button
down button
PRESENT TIME
PM