Advertisement
Starter Interrupt
Socket & Relay
(not included)
To Ignition
Switch
LINKR-M1_EN-04/22/16
LINKR-M1 install guide EN A6.indd 7
Black 4-Pin Data Port Connector
Serial data installation: Program host system for iDatalink
protocol and connect this to the system's matching data port.
Hardwire installation: Cut and remove connector from harness.
PINK Serial Data
BLACK/WHITE Serial Data
BLACK System Ground (-) Input
5 A
RED Constant 12v (+) Input
YELLOW (+) Ignition Input
BROWN/WHITE (-) Pulsed Alarm Trigger Input
BROWN (+) Steady Alarm Trigger Input
BLUE (-) Output 1
GREEN (-) Output 2
GRAY/BLACK (-) Button Input
ORANGE (-) Output 3
TYPICAL INSTALLATION
RED
cut starter
wire
ORANGE
WHITE
To Starter
WIRE LEGEND
Hard wire connection required
Supported via DATA port(s)
(Horn Honk/Light Flash)
(Alarm Siren)
Panic/Override
Button
Ground
5/24/2016 4:00:51 PM
7
Advertisement
