Advertisement
Step 2: Determine A Mounting Location
Find a discreet and secure mounting location for the module. Make
sure the module is free from moisture, excessive heat, direct sunlight, or
moving vehicle parts.
- The large white sticker must be facing towards the sky
- There cannot be any metal between the module and the sky
- Mount as high in the dash as possible
- Mount at least 12 inches away from the radio & speakers. The cellular
portion of this device could cause radio interference.
- DO NOT SECURE THE DEVICE UNTIL TESTING IS COMPLETE
Step 3a: Connect The Device - Serial / Data Port Installation
NOTE: IF YOU ARE NOT CONNECTING TO A DATA PORT AND
BLACK 4-Pin Serial Data Connector (required):
This allows for a quick plug-in installation when used with a compatible
Omega security or remote start system. Plug this into the matching port
on the host system and program the data port for iDatalink protocol.
Power and Ground are provided by the data port.
YELLOW +12v Ignition input wire (optional):
This is an ignition input wire to the device. It must be connected to an
ignition +12V source. This can be found in the ignition switch harness
or at a fuseblock. Be certain that this wire has +12V with the ignition
key is in the ON position.
NOTE: DO NOT CONNECT IF USING DATA CONNECTOR WITH AN
OMEGA ALARM OR REMOTE START SYSTEM.
BLUE (-) output #1 wire (optional):
This is a negative pulse 150mA output (add a relay if necessary)
configurable for 0.8 second, 3 second, or 10 second pulse. It can be
assigned to most command buttons in the Linkr app.
LINKR-M1_EN-04/22/16
LINKR-M1 install guide EN A6.indd 3
HARDWIRING ALL CONNECTIONS, SKIP TO STEP 3B
Plug-N-Play
3
5/24/2016 4:00:51 PM
Advertisement
