Table of Contents
Advertisement
Available languages
Available languages
5.3. Chain sharpening.
Pay attention to cutting tools. Cutting tools should be sharp and clean, it allows efficient and safe operation.
Operating the saw with blunt chain causes quick wear of the chain, guide bar and driving chain wheel, and
breaking the chain in the worst case. That is why it is important to sharpen the chain on time.
Chain sharpening is a complex operation. Sharpening the chain by yourself requires use of special tools
and skills. It is recommended to entrust sharpening the chain to qualified persons.
All faults should be repaired by service workshop authorized by the RAIDER.
6. Environmental protection.
Never place any electric tools in your household refuse.
To comply with European Directive 2002/96/EC concerning old electric and electronic equipment and its
implementation in national laws, old electric tools have to be separated from other waste and disposed of in
an environment-friendly fashion, e.g. by taking to a recycling depot.
Recycling alternative to the demand to return electrical devices:
As an alternative to returning the electrical device, the owner is obliged to cooperate in ensuring that the
device is properly recycled if ownership is relinquished. This can also be done by handing over the used
device to a returns center, which will dispose of it in accordance with national commercial and industrial
waste management legislation. This does not apply to the accessories and auxiliary equipment without any
electrical components which are included with the used device.
Faults
Pole saw does not
start to work
The engine is on,
but the knife does
not rotate.
Engine is turned off
suddenly.
Unusual noise.
Removal
Power cable is not connected or damaged
It is possible that the mower is fuzzy and
the blade is blocked.
Plug is withdrawn
Bolt is loose or the blade connections
between fasteners.
Reasons
Check cable. If necessary, replace it.
Disconnect the plug and check it. Put
on your protective gloves and clean
the knife and release
Check cable.
Fasten the parts.
21
Advertisement
Table of Contents
