Table of Contents
Advertisement
1. Current control
Adjusts the machines output current.
2. Digital display
Indicates welding current in Amps, also gives an indication when the machine is over temperature.
3. Arc force control
Operates in MMA mode only. This control alters the welding dynamics of the machine to facilitate welding
with different types of welding electrodes (e.g. general purpose, celulosic, low hydrogen and iron powder).
Turning towards maximum will increase penetration at the expense of increased welding splatter, turning
towards minimum will reduce penetration but the arc will be smoother and less fierce.
4. Off/On switch
Switches the machine on and off when the main 3 Phase isolation switched is in the on position. Upon
switching on, the display will read "7000" and the machines output will be inhibited, after 4 seconds the
display will clear and the machine is ready to be used.
5. Remote control socket
For connection of external remote control or TIG300 external TIG control unit. There is no switch for remote
operation, plugging an external unit into the socket automatically selects remote operation and disables the
internal current control.
6. -ve weld terminal
Main welding power output connector, negative polarity.
7. +ve weld terminal
Main welding power output connector, positive polarity.
8. Remote supply fuse
Protects the auxiliary supply from the remote control socket. Fuse type is 20 x 5mm glass body, 6.3A 'slow
blow' rating.
9. Auxiliary transformer supply fuse
Fuse 3.15A slow blow, 32 x 6.3mm ceramic body.
10. Main 3P isolation switch
Switches the machine on and off.
11. Mains input
Three phase mains cable
11
R7000
Advertisement
Table of Contents
