Ecomiser SR-04 Manual page 16

* If the FLOAT SWITCH is turned off before the washing cycle begins, LED will not work.
2) Detergent
* At programmed time, detergent will be supplied.
3) Waiting
* After the washing cycle, machine will be put onto waiting mode.
* Machine will stop for previously set time.
4) Rinsing
* Rinsing cycle is in operation.
* After programmed time, rinsing cycle will end.
5) Rinse agent
* At programmed time, rinse agent will be supplied.
6) Finish
* When the rinsing cycle is finished, the WHOLE CYCLE is finished.
* FINISH LED will light up.
* END message will appear.
* After the ending buzzer sounds (3 times), for 30 seconds on the DISPLAY, END message
will appear.
* After 30 seconds, machine will be reset to the beginning.
3-5 ℃, ℉: Displays the temperature.
4. KEY
4-1 POWER
1) Turns the power ON.
2) While the power is turned OFF, everything is stopped.
3) While ERROR message is displayed, press the power button to clear the message.
4-2 START/STOP
1) Button is used to start and/or stop the whole cycle.
2) If you press the button while the door is opened, message PAU will be displayed. If the door
is closed while the PAU message is displayed, PAU mode will skip the cycle from starting
once.
3) While PAU message is displayed, push the START/STOP button to cancel the PAU mode.
4) START/STOP button will stop any ongoing cycle.
5) START/STOP button will manually stop the DRAIN CYCLE after the power is turned off.
4-3 MODE (Press and hold the button for 7 seconds to initiate MODE) If there is no activity for
more than 3 seconds, MODE will automatically exit.
1) Press MODE key 1 time  Configure WASHING cycle duration
2) Press MODE key 2 times  Configure DETERGENT cycle duration
3) Press MODE key 3 times  Configure WAITING MODE
4) Press MODE key 4 times  Configure RINSING cycle duration
5) Press MODE key 5 times  Configure RINSGE AGENET cycle duration
6) Press MODE key 6 times  Configure HIGH temperature
7) Press MODE key 7 times  Configure LOW temperature
8) Press MODE key 8 times  Configure BUZZER on/off setting
9) Press MODE key 9 times  Configure TEMPERATURE DISPLAY (℃,℉)
10) Press MODE key 10 times  Configure DRAIN cycle duration (DIP Switch UC Only)
11) Press MODE key 11 times  Show MODEL NUMBER
12) Press MODE key 12 times  DONE (To top of the list)
4-4 UP/DOWN
1) Within each mode, it will display time, temperature, and selections.
2) UP/DOWN key to increase or decrease certain variables.
3) When the system is not set in MODE, UP/DOWN key will display time remaining of the cycle.
4) When the machine is not running, UP/DOWN button will configure washing time duration
(65/90/120 seconds).
4-5 TEMPERATURE LOCK/UNLOCK
Ecomiser SR-04 / SR-04T Manual 16/25 Page Rev.06