Ecomiser SR-04 Manual page 11

4. DISPENSING SYSTEM CONNECTION
The Ecomiser SR-04 / SR-04T models are designed for use with a liquid rinse aid and detergent. The
Ecomiser SR-04 / SR-04T models equipped with liquid internal detergent and rinse aid pumps each
have a tube exiting the machine at the lower rear. These tubes can simply be attached to detergent and
rinse aid containers.
- Commercial (not a domestic) detergent must be used.
- Locate the red liquid detergent and blue liquid rinse aid tube at the lower rear of the machine.
Connect the tubes to the detergent and rinse aid container.
Figure 1-4 Liquid rinse & detergent injection
- This figure shows you how tubes are to be connected to
detergent / rinse containers.
a) Make a hole about 3mm bigger than the tube diameter
on the container cap (No. 1)
b) Insert the tube through the container cap into the sinker
cap (No. 2)
c) Tighten the sinker cap on to the sinker (No. 3)
d) Drop the sinker down to the bottom of the container to
supply chemical properly.
5. Detergent and Rinse agent setting
This mode will only work if the READY LED light is lit.
1) Detergent
While the power is turned on, press MODE and UP key simultaneously to supply detergent.
2) Rinse agent
While the power is turned on, press MODE and DOWN key simultaneously to supply rinse agent.
6. Straight-through and corner tabling configurations
The Ecomiser SR-04 / SR-04T models can be installed as a straight-through or corner tabling
configurations as in the following figures.
Ecomiser SR-04 / SR-04T Manual 11/25 Page Rev.06