Ecomiser SR-04 Manual page 15

CONTROL SYSTEM
1. Configuration of Display
* Hanging Type Remote Display controller
This controller can be placed anywhere within 3 meters of the machine to give flexibility with space.
2. Windows
2-1 Washing Tank Temp.
1) Displays the temperature of the washing tank, and RUN message.
2) Displays SETTING when MODE button is pressed.
2-2 Rinsing Tank Temp.
1) Displays the temperature of the rinsing tank, and NUMBER message.
2) During washing cycle, it will display the temperature of the rinsing tank temperature.
3) Displays the menu for SETTING when MODE button is pressed.
4) Displays ERROR message.
5) Displays END message after the complete cycle for 30 seconds  Message is cleared as
soon as the door is opened.
3. LED
3-1 Ready: Indicates that the cycle is fully ready. If the temperature requirement (Rinsing Tank:
82 ℃ or 180 ℉, Washing Tank: 50 ℃ or 122 ℉) is met, the message will be shown.
When the READY LED is not turned on, none of the buttons will work.
3-2 Tank Fill
1) Water will be supplied until both of the FLOAT S/W is turned on in rinsing and washing tank.
2) LED will be turned on while water is being supplied.
3) During wash cycle, even if the FLOAT S/W is turned off, water will not be replenished.
3-3 Heater
1) Will depend on the temperature settings.
2) When heater is working (FLOAT SWITCH ON/OFF status)
Process
Step 1
Step 2
Step 3
Normal
4) Depending on the temperature inside the lower and upper rinsing tank, the switch will go
ON/OFF.
3-4 Cycle LED: Will display during cycles. (Washing, Detergent, Waiting, Rinsing, Rinse agent, Finish)
1) Washing
* If the door is opened then closed, washing cycle will begin within 2 seconds.
* While door is closed, press START/STOP button to initiate the washing cycle.
* While READY LED is turned off, machine will not operate.
* After each cycle is completed, it will move in sequence.
Rinse tank lower Rinse tank upper
OFF
ON
ON
ON
Washing tank
OFF OFF
OFF OFF
ON OFF
ON ON
Ecomiser SR-04 / SR-04T Manual 15/25 Page Rev.06
Heater operation
OFF
ON
ON
ONOFFON Repeat