Table of Contents
Advertisement
ENG
the circuit breaker or fuse. Never clean the appliance with a steam
cleaner. Moisture could accumulate in electrical components, danger
of electrical shock! Hot vapors can lead to the damage of plastic
parts. The appliance must be dry before it is placed back into service.
IMPORTANT! Ethereal oils and organic solvents can attack plastic
parts, e.g. lemon juice or the juice form orange peel, butyric acid,
cleanser that contain acetic acid.
• Do not allow such substances to come into contact the appliance
parts.
• Do not use any abrasive cleaners
• Remove the food from the freezer. Store it in a cool place, well
covered.
• Switch the appliance off and remove the plug from the socket, or
switch off the circuit breaker or fuse.
• Clean the appliance and the interior accessories with a cloth and
lukewarm water. After cleaning wipe with fresh water and rub dry.
• Accumulation of dust at the condenser increases energy
consumption. For this reason, carefully clean
TROUBLESHOOTING
CAUTION!
Before troubleshooting, disconnect the power supply. Only a qualified electrician of competent person must do the troubleshooting that is not
in this manual.
IMPORTANT! There are some sounds during normal use (compressor, refrigerant circulation).
Problem
Appliance does not
work
Appliance freezes too
much
The food is not frozen
enough.
Heavy build-up of frost
on the door seal.
Unusual noises
If the malfunction shows again, contact the Service Center.
These data are necessary to help you quickly and correctly. Write the necessary data here, refer to the rating plate.
Possible cause
Power plug is not plugged in or is loose
Fuse has blown or is defective
Socket is defective
Temperature is set too cold or the appliance runs
at MAX setting.
Temperature is not properly adjusted.
Door was open for an extended period.
A large quantity of warm food was placed in the
appliance within the last 24 hours.
The appliance is near a heat source.
Door seal is not air-tight.
Appliance is not level.
The appliance is touching the wall or other
objects.
A component, e.g. a pipe, on the rear of the
appliance is touching another part of the
appliance or the wall.
• the condenser at the back of the appliance once a year with a soft
brush or a vacuum cleaner.
• After everything is dry place appliance back into service.
Defrosting of the freezer
The freezer compartment, however, will become progressively
covered with frost. This should be removed. Never use sharp metal
tools to scrape off frost from the evaporator as you could damage it.
However, when the ice becomes very thick on the inner liner,
complete defrosting should be carried out as follows:
• pull out the plug from the power socket;
• remove all stored food, wrap it in several layers of newspaper and
put it in a cool place;
• keep the door open, and placing a basin underneath of the
appliance to collect the defrost water;
• when defrosting is completed, dry the interior thoroughly
• put the plug back in the power socket to run the appliance again.
Solution
Insert power plug.
Check fuse, replace if necessary.
Socket malfunctions are to be corrected by an electrician.
Turn the temperature regulator to a warmer setting
temporarily.
Please look in the initial Temperature Setting section.
Open the door only as long as necessary.
Turn the temperature regulation to a colder setting
temporarily.
Please look in the installation location section.
Carefully warm the leaking sections of setting). At the same
time shape, the sits correctly.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the component out of the way.
8
Advertisement
Table of Contents
