Table of Contents
Advertisement
ENG
INSTALLATION
Install door external handle
Rear spacer
Screw the rear spacers at the rear of the unit.
Space Requirement
• Keep enough space for opening of doors.
• Keep at least 50mm gap at two sides.
Levelling the unit
To do this adjust the two levelling feet at front of the unit.
If the unit is not level, the doors and magnetic seal
alignments will not be covered properly.
screw
Positioning
Install this appliance at a location where the ambient temperature
corresponds to the climate class indicated on the rating plate of the
appliance:
Climate class
SN
N
ST
T
Location
The appliance should be installed well away from sources of heat
such as radiators, boilers, direct sunlight etc. Ensure that air can
circulate freely around the back of the cabinet to ensure best
performance. If the appliance is positioned below an overhanging
wall unit, the minimum distance between the top of the cabinet and
the wall unit must be at least 100 mm. Ideally, however, the appliance
should not be positioned below overhanging wall units. Accurate
leveling is ensured by one or more adjustable feet at the base of the
cabinet.
6
Ambient temperature
+10ºC to +32ºC
+16ºC to +32ºC
+16ºC to +38ºC
+16ºC to +43ºC
Advertisement
Table of Contents
