Table of Contents
Advertisement
ENG
Defrosting of the freezer
The freezer compartment, however, will become progressively
covered with frost. This should be removed. Never use sharp metal
tools to scrape off frost from the evaporator as you could damage
it. However, when the ice becomes very thick on the inner liner,
complete defrosting should be carried out as follows:
• pull out the plug from the socket;
• remove all stored food, wrap it in several layers of newspaper and
put it in a cool place;
• keep the door open, and placing a basin underneath of the
appliance to collect the defrost water;
• when defrosting is completed, dry the interior thoroughly
• replace the plug in the power socket to run the appliance again.
TROUBLESHOOTING
CAUTION!
Before troubleshooting, disconnect the power supply. Only a qualified electrician of competent person must do the troubleshooting that is not
in this manual.
IMPORTANT! There are some sounds during normal use (compressor, refrigerant circulation).
Problem
Appliance does not
work
The food is too warm.
Appliance cools too
much
Unusual noises
Water on the floor
Side panel is hot
If the malfunction shows again, contact the Service Center.
Possible cause
Temperature regulation knob is set at number "0".
Power plug is not plugged in or is loose
Fuse has blown or is defective
Socket is defective
Temperature is not properly adjusted.
Door was open for an extended period.
A large quantity of warm food was placed in the
appliance within the last 24 hours.
The appliance is near a heat source.
Temperature is set too cold.
Appliance is not level.
The appliance is touching the wall or other
objects.
A component, e.g. a pipe, on the rear of the
appliance is touching another part of the
appliance or the wall.
Water drain hole is blocked.
Condenser is inside the panel.
Replace the lamp
CAUTION!
The product is equipped with LED light, please contact after sales
service in case of replacement.
Solution
Set the knob at other number to switch on the appliance.
Insert power plug.
Check fuse, replace if necessary.
Socket malfunctions are to be corrected by an electrician.
Please look in the initial Temperature
Setting section.
Open the door only as long as necessary.
Turn the temperature regulation to a colder setting
temporarily.
Please look in the installation location section.
Turn the temperature regulation knob to a warmer setting
temporarily.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the component out of the way.
See the Cleaning section.
It's normal.
8
Advertisement
Table of Contents
