Table of Contents
Advertisement
9
10
INSTALLATION
Install door external handle (if external handle is present)
Rear spacer
Screw the rear spacers at the rear of the unit.
Reverse the middle
hinge by 180o , then
transfer it to the left
side position. Make the
middle hinge pin in the
upper hole of the lower
door, then tighten the
bolts.
Place the upper door
back on. Ensure the door
is aligned
horizontally and vertically
so that the seal is closed
on all sides before finally
tightening the top hinge.
Then inert the hinge and
screw it to the top of
the unit.
screw
11
Space Requirement
• Keep enough space for opening of doors.
• Keep at least 50mm gap at two sides.
5
Put the top cover and
then screw back into
place.
ENG
Advertisement
Table of Contents
