Mocka Hudson Bar Stool Assembly Instructions

Hudson Bar Stool

Assembly Instructions

Thank you for your purchase.

Please follow the instructions below for correct assembly.

Socket Screw

35mm x12

Socket Nut

Once fully assembled please ensure all legs are sitting flush against

the stools underside to ensure stability. Do not over-tighten screws.

mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558

Socket Screw

30mm x2

25mm x4

Allen key

To ensure longevity of the wood please use a damp cloth only for

cleaning. Avoid use of household cleaners

Table of Contents

Need help?

Do you have a question about the Hudson Bar Stool and is the answer not in the manual?

Page 1 To ensure longevity of the wood please use a damp cloth only for the stools underside to ensure stability. Do not over-tighten screws. cleaning. Avoid use of household cleaners mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558...
Page 2 (A). Legs (C) are positioned at the front and Legs (B) at the back. Using 4x Socket Screws (G). Tighten the nuts and screws using the Allen Key the 12x screws (F) and the allen key (J) attach each leg to the seat. mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558...
Page 3 Fasten all screws and ensure all legs are sitting flush on the ground to Nuts (I) and Socket Screws (H). ensure stability. All done! Regularly check all screws are secure but not overly tightened. You’re done, enjoy! mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore BC, QLD, 4558...