AUXILIARY HYDRAULICS
BHydraulic Block Type Outlet
Hydraulic block type outlet is useful when adding
hydraulic operated equipment such as front end loader,
front blade, etc.
When implement is attached
1. Remove the block cover.
2. Attach the block outlet cover. (option)
(The block outlet cover is standard part for KUBOTA
implement.)
(1) Block cover
(A) From gear pump
(2) Block outlet cover (option)
(B) To implement inlet
(3) Outlet
(4) Inlet
(5) Hydraulic block
(C) From implement outlet
A For hydraulic block type outlet, be sure to use the
control valve of the "Power beyond type" with relief
valve that has a third line return to tank for the
operation of hydraulic block.
Max. flow
23 L/min
No relief valve in
the hydraulic block.
A The tank port flow from implement should be
connected to the port located on the right hand side of
transmission case.
(1) Return port
REMOTE HYDRAULIC CONTROL SYSTEM
(if equipped)
BRemote Control Valve Lever
Move the lever to the "FORWARD" or "REARWARD"
position and hold. This will raise or lower the implement.
Lever will return to neutral when released.
A Do not hold the lever in the "REARWARD" or
"FORWARD" position once the remote cylinder has
reached the end of the stroke, as this will cause oil to
flow through the relief valve. Forcing oil through the
relief valve for extended periods will overheat the oil.
A When using the tractor hydraulic system to power front
loader, do not operate boom and bucket cylinders
simultaneously.
HYDRAULIC UNIT
41