Table of Contents
Advertisement
3-6. Installation of the oil pan
(1) Remove the oil pan (No.1) from the accessory box then, set the oil bottle (No.2) to the oil pan (No.1).
(2) Put the oil pan at the position shown on the figure then, fix the oil pan with staples (No.3).
(3) Set the damper cushions (No.4) to the table.
<3>
<4>
>
上側
3-7. Installation of the machine head
(1) The sewing machine is heavy. For the safety, please make sure to install the sewing machine head
by more than one person.
(2) When tilting the sewing machine, please stand at the hinge side and hold the sewing machine with
both hands. Also, please lock the caster on the steel stand.
(3) When tilting the sewing machine, the work clamp slides toward the hinges. Remember to move the
work clamps fully to the right side of the table and attach the stopper before tilting the sewing head.
(1) Put the machine head carefully on the damper cushion.
(2) Insert the hinge shafts (No.1) into the hole on the machine and fix with set screws (No.2).
(3) Fit the hinge rubbers (No.4) and the support plates (No.5) into the holes of the hinges (No.3) then, set
the hinges to the hinge shafts.
(4) Fit the screw holes of the hinges (No.3) to the bolt setting holes then, fix the machine with the socket
bolts (No.6) and the flat washers (No.7).
<2>
<1>
<1>
<2>
<4>
CAUTION
<7>
<6>
<1>: Oil pan
<2>: Oil bottle
<3>: Staple (four staples)
<4>: Damper cushion
<3>
<5>
<4>
- 5 -
(six cushions)
<1>: Hinge shaft (two shafts)
<2>: Set screw (two screws)
<3>: Hinge (two hinges)
<4>: Hinge rubber (two rubbers)
<5>: Support plate (two plates)
<6>: Socket bolt (four bolts)
<7>: Flat washer (four washers)
Advertisement
Table of Contents
