Installation Of The Oil Pan; Installation Of The Machine Head - Mitsubishi Electric PLK-G2516 Technical Manual

2-6. Installation of the oil pan

(1) Remove the oil pan A and B (No.1,No.2) from the accessory box then, set the oil bottle (No.3) to the
oil pan A and B (No.1,No.2).
(2) Put the oil pan at the position shown on the figure then, fix the oil pan with staples (No.4).
(3) Set the damper cushions (No.5) to the table.
<4>
<5>
Upside

2-7. Installation of the machine head

(1) The sewing machine is heavy. For the safety, please make sure to install the sewing machine head by
more than one person.
(2) When tilting the sewing machine, please stand at the hinge side and hold the sewing machine with
both hands. Also, please lock the caster on the steel stand.
(3) When tilting the sewing machine, the work clamp slides toward the hinges. Before tilting the sewing
machine, insert the accessory hexagonal wrench into the fitting of work clamp to prevent the sliding of
work clamp. And then before driving the sewing machine, remember to remove the hexagonal
wrench.
(1) Put the machine head carefully on the damper cushion.
(2) Insert the hinge shafts (No.1) into the hole on the machine then, fix it to the machine with set screws
(No.2).
(3) Fit the hinge rubbers (No.4) and the support plates (No.5) into the holes of the hinges (No.3) then, set
the hinges to the hinge shafts.
(4) Fit the screw holes of the hinges (No.3) to the bolt setting holes then, fix the machine with the socket
bolts (No.6) and the flat washers (No.7).
(5) Fix the head rest (No.8) with safety socket bolts (No.9).
From the library of Superior Sewing Machine & Supply LLC - www.supsew.com
<2>
<1>
<5>
CAUTION
- 4 -
<1>: Oil pan A (large)
<2>: Oil pan B (small)
<3>
<3>: Oil bottle (two bottles)
<4>: Staple (eight staples)
<5>: Damper cushion
(six cushions)