Installing The Table; Installing Blade - King Canada KC-1401FX Instruction Manual

INSTALLING THE TABLE

1. Locate the trunnion bracket (A) Fig.10 and bolt it securely to the bandsaw as
shown using two hex. bolts and spring washers (B). Then install the 90
bolt (C), thread a hex. nut onto the bolt and turn the bolt into the threaded hole in
the left, rear of the trunnion bracket.
2. Before installing table, it is recommended to remove the anti-rust protective
coating on the table top first using a cloth and paint thinner. Position the table (A)
Fig.11 so the bolts dangling from its underside align with the holes in the trunnion
bracket and lower it into place. Locate the two lock knobs (B), install them to the
dangling bolts under the trunnion bracket.
3. Table 90 ajustment: Adjust the 90
0
into the trunnion bracket, so that the table rests on it when it is 90
Lock the bolt in place by tightening the hex. nut down onto the trunnion bracket.
NOTE: This bolt must be removed if the table is tilted to the left.

INSTALLING BLADE

This saw uses a standard 93-1/2" blade, although it will take a maximum of 94" and
a minimum of 91-1/2" blade. Blade widths from 1/8" to 3/4" may also be used.
1. To install the blade, open the upper and lower blade guard covers.
2. Remove the table insert (A) Fig.12 from the center of the table, and pull out the
table pin (B) from the side of the table.
3. Loosen the blade tension by turning the tensioning knob (A) Fig.14 counter-
clockwise.
4. When installing the blade, make sure the blade is put on correctly, with the teeth
facing forward and pointing downward. To install the blade, slide the blade into the
table slot and the position it in between both the upper and lower blade guide
blocks and finally around the blade wheels.
5. Center the blade in the middle of both blade wheels and tighten the tensioning
knob (clockwise). Do not close the blade guard covers until the blade is tensioned
and tracking properly.
6. Reinstall the table insert (A) and table pin (B).
INSTALLING SIDE BLADE GUARD
1. Locate the side blade guard (A) Fig.13. With the upper and lower blade guard
covers opened, slide the side blade guard onto the left side mounting posts and
secure it in place with speial washer and pan head screws (B). Do not close the
blade guard covers until the blade is tensioned and tracking properly.
ASSEMBLY
0 table stop bolt (C) Fig.10 that was threaded
0 table stop
0 to the blade.
FIGURE 10
FIGURE 11
FIGURE 12
FIGURE 13