Electrical Information - King Canada KC-1401FX Instruction Manual

14" wood cutting bandsaw

Hide thumbs

Table Of Contents

Table of Contents

ALL ELECTRICAL CONNECTIONS MUST BE DONE BY A QUALIFIED ELECTRICIAN. FAILURE TO COMPLY MAY RESULT IN SERIOUS

INJURY! ALL ADJUSTMENTS OR REPAIRS MUST BE DONE WITH THE MACHINE DISCONNECTED FROM THE POWER SOURCE.

FAILURE TO COMPLY MAY RESULT IN SERIOUS INJURY!

POWER SUPPLY

WARNING!: YOUR WOOD BANDSAW MUST BE CONNECTED TO A 120V, 15-AMP,

BRANCH CIRCUIT. FAILURE TO CONNECT IN THIS WAY CAN RESULT IN INJURY

FROM SHOCK OR FIRE.

GROUNDING

This Wood Bandsaw must be grounded. If it should malfunction or breakdown,

grounding provides a path of least resistance for electric current, reducing the risk of

electric shock. This Wood Bandsaw is equipped with a cord having an equipment

grounding conductor and grounding plug. The plug must be plugged into an

appropriate outlet that is properly installed and grounded in accordance with all local

codes and ordinances. Not all outlets are properly grounded. If you are not sure if your

outlet is properly grounded, have it checked by a qualified electrician.

WARNING!: IF NOT PROPERLY GROUNDED, THIS WOOD BANDSAW CAN

CAUSE ELECTRICAL SHOCK, PARTICULARLY WHEN USED IN DAMP

LOCATIONS. TO AVOID SHOCK OR FIRE, IF THE POWER CORD IS WORN OR

DAMAGED IN ANY WAY, HAVE IT REPLACED IMMEDIATELY.

WARNING!: TO MAINTAIN PROPER GROUNDING OF YOUR WOOD BANDSAW, DO

NOT REMOVE OR ALTER THE GROUNDING PRONG IN ANY MANNER.

120V OPERATION

As received from the factory, your Wood Bandsaw is ready to run for 120V operation.

This Wood Bandsaw is intended for use on a circuit that has an outlet and a plug which

looks like the one illustrated in Fig.1.

WARNING!: DO NOT USE A TWO-PRONG ADAPTOR FOR THEY ARE NOT IN

ACCORDANCE WITH LOCAL CODES AND ORDINANCES. NEVER USE IN CANADA.

EXTENSION CORDS

The use of any extension cord will cause some loss of power. Use the chart Fig.2 to

determine the minimum wire size (A.W.G-American Wire Gauge) extension cord

needed. Use only 3-wire extension cords which have 3-prong grounding type plugs and

3-hole receptacles which accept the tool's plug. For circuits that are further away from the

electrical circuit box, the wire size must be increased proportionately in order to deliver

ample voltage to the motor. Refer to Fig. 2 for extension cord length and size (gauge).

KC-1401FX WIRING DIAGRAM

POWER CORD

TO SWITCH