Table of Contents
Advertisement
LIGHTING
LIGHTING
NOTE: When you first use your new heater, ignite it out of the living area of your house, either in a garage or on area
NOTE: When you first use yo
outside protected from strong drafts. Burn it for about 15 minutes to remove all of the protective oil present
outside protected fro
on the burner parts. If this 15 minutes "burn-in" is done inside, some objectionable odor will be observed.
on the burner parts.
This procedure is necessary ONLY THE FIRST TIME your ignite your heater.
This procedure is nec
NOTE: If you have fueled your heater for the first time, or if you are refueling it after it has been out of fuel
NOTE: If you have fueled y
for a long time, you will need to wait about 30 minutes for the wick to become fully saturated.
for a long time, you
1. Turn the wick adjuster knob clockwise until it stops.
1. Turn the wick adjuster kno
It makes a spark discharge sound in the process of lighting procedure, but turn
It makes a spark discharg
the wick adjuster knob clockwise until it stops.
the wick adjuster knob clo
As the wick rises within the heater, the wick adjuster knob turns with some
As the wick rises within
resistance and makes a sound like the winding of a clock. Once the wick has
resistance and makes a s
reached its proper height, the automatic extinguisher is fully engages.
reached its proper height,
The wick adjuster knob can now move freely left or right to adjust the flame.
The wick adjuster knob ca
2. LIGHTING WITH A MATCH
2. LIGHTING WITH A MATCH
You should not have to light the heater with a match, but should it become
You should not have to
necessary, open the grille, lift the heat chamber up by holding the wire handle and
necessary, open the grille,
touch the match to the top of the wick.
touch the match to the top
DO NOT allow burned parts of the match to fall or remain on the wick.
DO NOT allow burned part
NOTE: To restore the automatic igniter system to proper operation, replace worn out
NOTE: To restore the automa
batteries.
batteries.
3. Be sure that heat chamber is properly seated by moving the wire handle left and
3. Be sure that heat chambe
right. If the movement is cough and jerky, it indicates that the heat chamber has
right. If the movement is c
not seated properly.
not seated properly.
NOTE: An improperly seated heat chamber can cause high flame, smoke, and
NOTE: An improperly seate
potential damage to the heater itself.
potential damage to
DO NOT leave the heater until you have determined that the flame is burning
DO NOT leave the he
normally, which will be described in the following section.
normally, which will b
6
Advertisement
Table of Contents
