Lennox Hearth Products EBVI25 Installation Instructions Manual

Elite series

Advertisement

f i r e - p a r t s . c o m
Report No. 116-F-15-5
WARNING: IF THE INFORMATION IN THIS MANUAL
IS NOT FOLLOWED EXACTLY, A FIRE OR EXPLO-
SION MAY RESULT CAUSING PROPERTY DAMAGE,
PERSONAL INJURY OR LOSS OF LIFE.
FOR YOUR SAFETY: Do not store or use gasoline
or other fl ammable vapors or liquids in the vicinity
of this or any other appliance.
FOR YOUR SAFETY: What to do if you smell gas:
• DO NOT light any appliance.
• DO NOT touch any electrical switches.
• Do not use any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow your gas suppliers
instructions.
• If your gas supplier cannot be reached, call
the fi re department.
Installation and service must be performed by a
qualifi ed installer, service agency or the gas sup-
plier
.

INSTALLATION INSTRUCTIONS

MANUAL
B-VENT GAS FIREPLACE HEATER INSERT
Elite™ Series, Model: EBVI25 & EBVI30
Suitable for installation into masonry or factory built fi replaces.
RETAIN THIS MANUAL FOR FUTURE REFERENCE
P/N 775,154M B, 7/2004
AVERTISSEMENT: ASSUREZ-VOUS DE BIEN SUIVRE
LES INSTRUCTIONS DONNÉ DANS CETTE NOTICE
POUR RÉDUIRE AU MINIMUM LE RISQUE D'INCENDIE
OU POUR ÉVITER TOUT DOMMAGE MATÉRIEL, TOUTE
BLESSURE OU LA MORT.
POUR VOTRE SÉCURITÉ: Ne pas entreposer ni utiliser
d'essence ni d'autre vapeurs ou liquides infl ammables
dans le voisinage de cet appareil ou de tout autre
appareil.
POUR VOTRE SÉCURITÉ: Que faire si vous sentez une
odeur de gaz:
• Ne pas tenter d'allumer d'appareil.
• Ne touchez à aucun interrupteur. Ne pas vous servir
des téléphones se trouvant dans le batiment où vous
vous trouvez.
• Evacuez la piéce, le bâtiment ou la zone.
• Appelez immédiatement votre fournisseur de gaz
depuis un voisin. Suivez les instructions du fournis-
seur.
• Si vous ne pouvez rejoindre le fournisseur de gaz,
appelez le service dos incendies.
L'installation et service doit être exécuté par un qualifi é
installeur, agence de service ou le fournisseur de gaz.

Advertisement

Table of Contents
loading

Summary of Contents for Lennox Hearth Products EBVI25

  • Page 1: Installation Instructions

    B-VENT GAS FIREPLACE HEATER INSERT f i r e - p a r t s . c o m Elite™ Series, Model: EBVI25 & EBVI30 Suitable for installation into masonry or factory built fi replaces. RETAIN THIS MANUAL FOR FUTURE REFERENCE Report No.
  • Page 2: Table Of Contents

    fi red heater. It In Canada, the current CSA C22-1 Canadian is our goal at Lennox Hearth Products to provide you, our valued customer, with an appli- Electrical Code - latest edition.
  • Page 3: General Information

    WARNING: DO NOT PLACE CLOTHING Feet Nat. Prop. OR OTHER FLAMMABLE MATERIALS ON (meters) GENERAL INFORMATION OR NEAR THIS APPLIANCE. EBVI25 0-4500 The appliance installation, repair and annual (.096") (.0595") (0-1372) WARNING: FAILURE TO COMPLY WITH inspection should be performed by a quali- THE INSTALLATION AND OPERATING fi...
  • Page 4: Questions/Building Offi Cials

    6. Maximum amount of gas pipe without a QUESTIONS TO ASK LOCAL BUILDING FIREPLACE REQUIREMENTS OFFICIAL pressure test - type of test required? 7. Are below grade penetrations of the gas IMPORTANT: When installing this appliance This appliance must be installed per into a factory built fi...
  • Page 5: Specifi Cations

    SPECIFICATIONS - Model EBVI25 DIMENSIONS SPECIFICATIONS inches (millimeter) inches (millimeter) Natural Gas BTU Input 17,000 to 25,000 Propane Gas BTU Input 19,500 to 25,000 26 5/8” (675 mm) 11 1/8” (282 mm) B-Vent Size 4” Dia. Liner 20 1/2” (520 mm) 1 1/4”...
  • Page 6 SPECIFICATIONS - Model EBVI30 SPECIFICATIONS DIMENSIONS Natural Gas BTU Input 21,500 to 30,000 inches (millimeter) inches (millimeter) Propane Gas BTU Input 22,000 to 28,000 26 1/16” (662 mm) 11 1/2” (292 mm) B-Vent Size 4” Dia. Liner 22 3/8” (568 mm) 15/16”...
  • Page 7: Clearance To Combustibles

    Hearth Protection Figure 5 Figure 3 Mantel Clearance, Model: EBVI30: The Mantel Clearance, Model: EBVI25: The Hearth Protection: For every 2" of hearth height, mantel should be located in the shaded mantel should be located in the shaded subtract 1" of hearth extension required.
  • Page 8: Step 1 Preparation

    Schedule 40 Pipe Figure 8 Schedule 40 Pipe Inside Diameter (Inches) Minimum Fire- Inches (millimeters) Length (Feet) place Clearance Natural Propane EBVI25 EBVI30 Dimensions DETAILED INSTALLATION STEPS Height 19" 21" 0-10 Step 1: PREPARATION - Plan and install gas (483 mm) (533mm) line.
  • Page 9: Step 3 Unpack The Insert

    STEP 6: REMOVE PACKAGED MATERIALS CAUTION: THE FIREPLACE IN WHICH 1) Open the 2 latches below the glass door FROM INSIDE FIREBOX AND SET ASIDE ( as shown in Figures 9 & 10. THIS GAS INSERT IS TO BE INSTALLED set, bag of embers, bag of vermiculite, MUST BE THOROUGHLY CLEANED IF IT propane conversion kit.
  • Page 10 (see Figure 14). Note: Mill-pac, high temperature silicone and/or screws may also be used to secure the liner Lennox Hearth Products - 4" B-Vent Kits to the collar (hose clamp must also be used). Ensure that the draft hood assembly is level with the insert top for attachment.
  • Page 11 Vent Before installing liner, Masonry Fireplace Installation Diagram ensure that the damper plate is open and Liner Vertical secure to prevent the Vent Kits, HO906 (25') Term. Cap damper plate from fall- Flex & H0907 (35') includes: Collar ing down and crushing 1 ea.
  • Page 12: Step 9 Connect Gas Line

    Step 9. CONNECTING GAS LINE Factory Built Fireplace Installation Diagram Note: Final gas connection should be made after unit is in place to avoid Liner Vertical damage to line when pushing the unit into position. Vent Kits, HO906 (25') Term. Cap &...
  • Page 13: Step 11 Install Log Set

    Step 11. INSTALLING LOGS, VERMICULITE AND EMBERS The packaged log set, vermiculite and embers are located within the fi rebox of the insert Rear Log Top Left Log Front Center Log Top Right Log Center Log Front Left Log Figure 21 Front Right Log f i r e - p a r t s .
  • Page 14: Step 13 Perform Leak Test

    4. Place the Front Left Log onto the 2 corresponding locating pins as shown in Figure 25. Front Left Log Figure 25 Figure 28 Top Right Log 8. Place the glowing embers on the burner as shown in Figure 29. 5.
  • Page 15: Step 12 Reinstall Front Glass Door

    (see Figure 34) or operate insert. Wire the thermostat within the millivolt MODEL EBVI25 the burner with the optional remote control, control circuit using a maximum of 25 feet of wall thermostat or control switch.
  • Page 16: Step 17 Perform Spillage Test

    Air for combustion is drawn in through the If spillage continues, it may be a result of nega- Step 17. SPILLAGE TEST PROCEDURE front of the unit therfore, the front of the unit tive air pressure within the home. To test: (Proper Vent Operation Test): must be kept clear of any obstructions.
  • Page 17: Step 19 Adjust Burner

    fi nish the installation. (1/8" Open Position) Leave the control knob in the ON position and Figure 39 EBVI25 Burner Tube the on/off switch in the OFF position. Sooting is indicated by black puffs developing STEP 20. INSTALL LOUVER KIT at the tips of very long orange fl...
  • Page 18: Rating Plates

    SAFETY / LISTING LABEL MODEL NO. MODEL NO. EBVI25 EBVI30 MANUFACTURED AT: MANUFACTURED AT: Lynwood, CA Union City, TN FOR USE WITH NATURAL GAS. EQUIPE POUR GAZ NATUREL FOR USE WITH NATURAL GAS. EQUIPE POUR GAZ NATUREL ALTITUDE 0-4500 FT/PI...
  • Page 19 f i r e - p a r t s . c o m...
  • Page 20 Lennox reserves the right to make changes at any time, without notice, in design, materials, specifi cations, prices and also to discontinue colors, styles and products. Consult your local distributor for code requirements for your area. Printed in U.S.A. © LENNOX HEARTH PRODUCTS 2004 P/N 775,154M REV. B 7/2004 1110 West Taft Avenue •...

This manual is also suitable for:

Ebvi30

Table of Contents