Cord Instructions; Installation Instructions; Before Using Your Ice Maker; Installation Of Casters - Vinotemp DESIGNER Series Manual

Vinotemp International ● 17621 S. Susana Road, Rancho Dominguez, CA 90221
For your protection, this unit should be properly
grounded. Unit is equipped with a 3-conductor cord
set that has a molded 3-prong grounding-type plug,
and should be used in combination with a properly
connected grounding-type outlet as shown in figure A.
It is not recommended to use this ice maker with an
extension cord or power board. Please ensure that
the appliance is plugged directly into the electrical
outlet.

INSTALLATION INSTRUCTIONS

Before Using Your Ice Maker

• Remove all exterior and interior packing material.
• Before connecting the ice maker to the power source, let the unit stand
upright for 24 hours. This will reduce the possibility of malfunction in the
cooling system from transportation.
• The ice maker should be cleaned before the first use. Please see Care and
Maintenance for further instructions.

Installation of Casters

Casters are necessary for a mobile install and are ideal for rolling the unit from
one location to another.
• Turn the leveling casters to the right
• Tighten casters without locks in the impressions at the back of the unit.

Positioning Your Ice Maker

• Position the unit in a dry and well-ventilated place. Avoid placing the ice
maker near any source of heat or moisture, or in direct sunlight. The
recommended ambient temperature should be between 50° and 100°F.
• To allow for proper circulation, the ice maker requires at least a 4" clearance
at the back, 1" clearance at the sides and 1" clearance at the top. The front
of the ice maker should be unobstructed. The installation should allow for the

CORD INSTRUCTIONS

7