Vinotemp DESIGNER Series Manual page 10

Vinotemp International ● info@vinotemp.com ● P: 1.800.777.8466 ● F: 310-886-3310
o Flathead screwdriver
o Phillips head screwdriver
• To remove the door from the hinges:
o Remove the top of the hinge cover
o Using a Phillips head screwdriver, remove the screws, and then
remove the top hinge mat and top hinge. Keep the parts together
and set them aside.
• To reinstall the door on the opposite side hinge;
o Using a flathead screwdriver, remove the plug buttons from the
screw holes opposite the door hinges, top and bottom. Set the parts
aside.
o Remove the front vent panel and set it aside.
o Remove the bottom hinge and place it on the opposite side at the
bottom of the door.
o Position the door on the bottom hinge.
o Align the door on the bottom hinge and replace the top hinge and
top hinge mat.
o Replace the top hinge cover.
o Push the plug buttons into the original screw holes (See figure
below).
10