Operating Your Wine Cooler - Vinotemp element EL-54COMM Owner's Manual

Operating Your Wine Cooler

The Wine cooler should be placed in a position where the ambient temperature is
between 12-38°C/54-100°F. Humidity level is between 45~90%. If the position is
above or below this range, the performance of the unit may be affected. For example,
placing your unit in extreme cod or hot conditions may cause interior temperature to
fluctuate.
NOTE:
 When you use the wine cooler for the first time or restart the wine cooler after
having been shut off for a long time, there could be a few degrees variance
between the temperature you select and the one indicated on the LED readout .
This is normal and it is due to the length of the activation time. Once the wine
cooler is running for a few hours everything will be back to normal.
 If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes
before restarting the unit. If you attempt to restart before this time delay, the wine
cooler will not start.
The controls of your wine cooler
Up
1
Used to raise (warm)the set temperature by 1°C or 1°F .
Temperature Display
2
°C /°F Display
3
Down
4
Used to lower (cool) the set temperature by 1°C or 1°F .
Set temperature
5
press this bottom, press
temperature at any time, touch the UP or DOWN mark, the "set" temperature will
temporarily "flash" in the LED display for 5 seconds.
°F /°C Selector
6
Select the temperature display setting in Fahrenheit or Celsius degree.
7 3 2 S o u t h R a c e t r a c k R o a d , H e n d e r s o n , N e v a d a 8 9 0 1 5
to set temperature. To view the "set"
1
i n f o @ v i n o t e m p . c o m
11