Table of Contents
Advertisement
ELECTRONIC CLOCK
The programmer is equipped with an
electronic clock with illuminated numbers
which indicates hours and minutes.
Upon immediate connection of the oven or
after a power cut, three zeros will flash on
the programmer display.
To set the correct time of day it is necessary
to push the
button and then the
button until you have set the correct time
(fig. 19).
In another way push simultaneously the
two buttons and at the same time
push the
or
Note: If the clock is reset it deletes any
previously set programs
NORMAL COOKING WITHOUT THE
USE OF THE PROGRAMMER
To manually use the oven, without the aid
of the programmer, it is necessary to cancel
the flashing AUTO by pushing the
(AUTO will be switched off and the symbol
will illuminate - fig. 20).
Attention: If the AUTO is illuminated (which
means a cooking program has already
been inserted), by pushing the button
you cancel the program and return to
manual operation.
If the oven is switched on, you must switch
off manually.
Figure 20
(fig. 19)
button.
button
ELECTRONIC TIMER
The timer program consists only of a
buzzer which may be set for a maximum
period of 23 hours and 59 minutes.
If the AUTO symbol is flashing push the
button.
To set the time, push the
or
or
the display (fig. 21).
Having finished the setting, the clock hour
will appear on the panel and the
will be illuminated.
The countdown will start immediately and
may be seen at any moment on the panel
by simply pressing the button
At the end of the time, the
disappear and the buzzer will sound and
continue for approximatley 7 minutes or
until a button is pressed (not the
buttons). After a short time the display will
revert back to the time of day.
SETTING THE FREQUENCY OF THE
AUDIBLE SIGNAL
The buzzer has 3 different tones and can
be changed by pressing the
only when the time of day is displayed
Figure 21
until you obtain the desired time in
button and the
symbol
.
symbol will
/
button, but
27
Advertisement
Table of Contents
