Honda CB110C3M Manual page 72

Side Stand Adjusting the Drive Chain Slack
►
5. Turn both adjusting nuts an equal number of
turns until the correct drive chain slack is
obtained. Turn the adjusting nuts clockwise
to tighten the chain. Turn the adjusting nuts
counterclockwise and push the rear wheel
toward the front to provide more slack.
Adjust the slack at a point midway between
the front sprocket and the rear sprocket.
Check the drive chain slack. 2 P. 67
6. Check rear axle alignment by making sure
the end of the chain adjuster aligns with the
scale graduations on both sides of the
swingarm.
Both marks should correspond. If axle is
misaligned, turn the right or left adjusting
nut until the marks are aligned and recheck
chain slack.
7. Tighten the rear axle nut.
Torque: 54 N·m (5.5 kgf·m, 40 lbf·ft)
8. Tighten the drive chain adjusting nuts lightly,
then hold the adjusting nuts and tighten the
lock nuts.
9. Recheck drive chain slack.
70
10. Rear brake pedal freeplay is affected when
repositioning the rear wheel to adjust the
drive chain slack. Check rear brake pedal
freeplay and adjust as necessary. 2 P. 58
11. Reinstall the inspection hole cap.
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.