Table of Contents
Advertisement
6. Allow the cleaning solution to fully evaporate before powering
up the product.
Cleaning the Dock Auxiliary Battery Contacts
1. Remove the power cable and the Ethernet module before
cleaning the contacts.
2. Use a soft dry cloth as suggested above. If the product is very
dirty, moisten the cloth in a non-aggressive cleaning solution or
diluted isopropyl alcohol solution (20% maximum).
3. Gently rub the cloth back and forth ONLY along the contacts,
following the directions indicated by the red arrows. Use care
not to leave any cloth residue.
4. Use a dry cloth to remove any dirt near the contacts area and to
clean the plastic parts. If the plastic parts of the equipment are
very dirty, slightly dampen the cloth with only water.
5. Repeat steps 2, 3 and 4 using a clean dry cloth.
6. Allow the cleaning solution to fully evaporate before powering
up the product.
User's Manual
Maintenance
213
Advertisement
Table of Contents
