Table of Contents
Advertisement
9. Select the Enable Service check box.
10. Tap Home to exit.
To authenticate Remote Control when a password is set on the
device:
1. Launch DXU.
2. Connect the device to DXU either directly using USB or through
the network via Wi-Fi or Ethernet, or scan a Scan2Pair label.
3. Click the device button in the Available Device list.
4. Click the Remote Control button.
5. Type the device's VNC password in the field, and then click OK.
Set or Edit the VNC Authentication Password from DXU
You can change a device's VNC password from DXU. It is a
configuration parameter in the Device Configuration window. Follow
the steps below:
1. Open a configuration file or load the configuration from a
connected device.
2. Click the Configure This Device.
3. Click the DXU Configuration tab.
4. Click the General Settings node in the middle pane.
5. Type a password in the VNC Authentication Password field, or
edit the value in that field.
The value in this field is encrypted for security. Once
entered, it will be displayed as asterisks.
NOTE
User's Manual
Datalogic Applications
131
Advertisement
Table of Contents
