Table of Contents
Advertisement
FINAL ASSEMBLY
Place the washers onto their locations as shown in Figure K, being careful to check the sizes. Then, tighten
the hex nuts onto the potentiometers noting their size as shown in Figure K. Finally, fasten the spacers onto
the top panel with two 4-40 x 1/4" black screws.
9mm Hex Switch Nut
9mm x 15mm Flat Washer
7mm Hex Pot Nuts
8mm x 14mm Washers
4-40 x 1/4"
Screws
Figure K
Spacers
Install the handle as shown in Figure L.
Cut two pieces of weather stripping. Remove the protective backing and place a piece of weather strip on the top
panel in the location shown in Figure L. Then, place the other piece on the case in the location shown.
Handle
Top Panel
PC Board
Figure L
Weather Strip
Weather Strip
Bottom Case
Battery
The battery should fit like this.
-8-
Advertisement
Table of Contents
