Elenco Electronics FG-600K Assembly And Instruction Manual page 7

ASSEMBLE COMPONENTS TO THE PC BOARD
S1 - 6 position Rotary Switch
(see Figure C)
C1 - 100 F 16V Electrolytic
(see Figure D)
C9 - 1000 F 16V Electrolytic
(see Figure D)
BT - Battery Snap
(see Figure F)
S3 - Slide Switch
Figure C
Mount down flush with PC
board.
Cut off
tab
Thread the battery snap wires through the hole in the PC board from the solder
side as shown. Solder the red wire to the BT+ point and the black wire to the BT-
- point on the PC board.
Black Wire (BT--)
Red Wire (BT+)
Figure D
Electrolytic capacitors have polarity. Be sure to
mount them with the negative (--) lead (marked
on side) in the correct hole. Bend the electrolytic
capacitors as shown.
Figure F
Black Wire (BT--)
Red Wire (BT+)
-6-
R3 - 100k Pot PC Mount
(see Figure E)
R2 - 10k Pot PC Mount
7mm Hex Pot Nut
(see Figure E)
Jumper Wire
Jumper Wire
(see Figure G)
J1 - 3" Black Wire
J2 - 3" Black Wire
J3 - 3" Black Wire
(see Figure H)
S2 - Slide Switch
Figure E
Cut off tab
Mount the pots down flush with
the PC board. For R2, install nut.
Figure G
Form a discarded piece of an
electrolytic lead into a jumper wire
by bending the wire into the correct
length and mounting it to the PC
board.
Figure H
Cut three 3" wires and strip 1/4" of
insulation off of both ends of the
wires. Solder these wires to the
points J1, J2 and J3.