Elenco Electronics FG-600K Assembly And Instruction Manual page 8

Install the colored binding posts to the panel as shown in Figure I. Use the hardware shown in the figure.
WIRING
Attach the 3" black wire from point J3 on the PC board, to the black binding post, then solder into place (see
Figure J).
Attach the 3" black wire from point J2 on the PC board, to the middle green binding post, then solder into
place (see Figure J).
Attach the 3" black wire from point J1 on the PC board, to the other green binding post, then solder into place
(see Figure J).
Figure J
Black Binding Post
Black
Wire from J2
Wire from J3
Green Binding Posts
Nut
Lockwasher
Backside of
Panel
Small Nut
Binding Post
Green
Green
Figure I
-7-
Wire from J1