Table of Contents
Advertisement
FINAL ASSEMBLY
Fit the panel onto the PC board assembly. Be sure that all switches and pots come through the holes in the
panel as shown in Figure K.
Place the washers onto their locations as shown in Figure K, being careful to check the sizes. Then, tighten
the hex nuts onto the potentiometers and rotary switch noting their size as shown in Figure K. Finally, fasten
the spacers onto the top panel with two 4-40 x 1/4" black screws.
9mm Hex Switch Nut
9mm x 15mm Flat Washer
7mm Hex Pot Nuts
8mm x 14mm Washers
4-40 x 1/4"
Screws
Figure K
Spacers
Install the handle as shown in Figure L.
Cut two pieces of weather stripping. Remove the protective backing and place a piece of weather strip on
the top panel in the location shown in Figure L. Then, place the other piece on the case in the location shown.
Handle
Panel
PC Board
Figure L
Weather Strip
Weather Strip
Bottom Case
Battery
The battery should fit like this.
-7-
Advertisement
Table of Contents
