Elenco Electronics FG-600K Assembly And Instruction Manual page 10

Attach the battery snap to the battery. Insert the PC board assembly with the panel and battery into the case
(as shown in Figure L). Insert two 4-40 x 1/4" screws into the bottom case in positions shown in Figure M
and tighten in place.
Turn the shafts on the two potentiometers and rotary switch fully counter-clockwise. Push the three knobs
onto the shafts so that the line on the knob is on the point as shown in Figure N.
4-40 x 1/4" Screws
Figure M
TESTING THE FG-600 FUNCTION GENERATOR
The unit may be tested by following the 4 steps listed below. Should any of these tests fail, refer to the
Troubleshooting Guide.
1) Set the switches and pots as follows:
On/Off
Range
Frequency
Amplitude
Sine/Triangle
On
10
Maximum (clockwise)
Maximum (clockwise)
Set Sine/Triangle switch to Sine position
-9-
Figure N