Advertisement
Available languages
Available languages
FOR YOUR SAFETY READ BEFORE LIGHTING
If you do not follow these instructions exactly, a fire or explosion may result causing property damage,
personal injury or loss of life.
A. This appliance has a pilot which must be lighted by hand.
When lighting the pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas
is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any appliance.
•
Do not touch any electrical switch;
do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
•
If you cannot reach your gas supplier, call the fire de-
partment.
1.
STOP! Read the safety information to the left of this label.
2.
Set thermostat to lowest setting.
3.
Turn off all electric power to the appliance. (If applicable)
4.
Push in gas control knob slightly and turn clockwise
to "OFF". DO NOT FORCE.
5.
Wait ten (10) minutes to clear out any gas. Then smell for
gas, including near the floor. If you smell gas, STOP! Follow
"B" in the safety information above. If you do not smell gas,
go to the next step.
6.
Remove the pilot access cover located on the combustion
chamber.
7.
Find pilot -the pilot is attached to front of burner.
8.
Turn gas control knob counterclockwise
9.
Push in gas control knob all the way and hold in. Immediately
press the Piezo Ignitor repeatedly until the pilot is ignited.
Continue to hold the control knob in for about one (1) minute
after pilot is lit. Release knob and it will pop back up. The Pilot
should remain lit. If it goes out, repeat steps 4 through 9.
•
If knob does not pop up when released, stop and im-
mediately call your service technician or gas supplier.
•
If the pilot will not stay lit after several tries, turn the gas
control knob to "OFF" and call your service technician or
gas supplier.
10. Turn gas control knob counterclockwise
11. Turn on all electric power to the appliance. (If applicable)
12. Replace access panel (front panel).
13. Set thermostat to desired setting.
1.
Set thermostat to lowest setting.
2.
Turn off all electric power to the appliance. (If applicable)
If service is to be performed.
38151-4-0320
LIGHTING INSTRUCTIONS
LIGHTING INSTRUCTIONS
to "PILOT".
to "ON".
TO TURN OFF GAS TO APPLIANCE
WARNING
C. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by hand,
don't try to repair it; call a qualified service technician.
Force or attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system
and any gas control which has been under water.
3.
Push in gas control knob slightly and turn clockwise
to "OFF". Do not force.
Page 11
Advertisement
Chapters
