Daikin MC55VBFVM Operation Manual page 10

Read First
Preparation Before Operation
2
Preparing the remote controller
1.
Attach the remote controller holder.
• Insert the hook on the remote controller holder into
the notch in the back of the unit.
Notch
Insert all the way.
2.
Pull out the transparent sheet.
• After removing the transparent sheet, the remote
controller is ready for use.
Battery is
pre-loaded
How to use
• Direct the signal transmitter on the remote controller at
the signal receiver on the unit. The unit may fail to
receive signals if anything is obstructing the signals,
such as a curtain.
• Maximum transmission range is approx. 6m (straight line).
Signal
receiver
About the remote controller
• Make sure not to drop or allow water to get into the
remote controller. (Malfunction may result)
• Signal reception may be poor in rooms with electronic-
starter-type fluorescent lamps (inverter-type fluorescent
lamps etc.).
• Do not use near lighting equipment (within 1m).
(Decline in the receptivity of the remote controller signal
receiver or discolouration may result)
3
Attaching the deodorising filter
• For the attachment method, refer to the notice adhered to the deodorising filter.
4
Insert the power supply plug into the socket
• The sensitivity of the odour sensor will be determined by odour levels
in the first minute (approx.) after the power supply plug is inserted.
Insert the power supply plug when the air is clean (odour-free).
9
Transparent
sheet
[Viewed from above]
Signal
transmitter
Approx. 4m Approx. 4m
30° 30°
Approx. 6m
Replacing the battery
1.
Move the catch on the cover at the bottom of the
remote controller in the direction of the arrow.
2.
Pull out the cover.
3.
Replace the battery.
4.
Hook
Return the cover to its original position.
Catch
About the battery
• Keep batteries out of reach of children.
In the event that batteries are swallowed, go immediately
to the nearest medical emergency services.
• To avoid possible injury or damage from battery leakage
or rupturing, remove the battery when not using the
product for long periods of time.
• If the battery solution should get in the eyes, do not rub
the eyes. Instead, immediately flush the eyes with tap
water and seek the attention of a medical professional.
• Do not expose batteries to heat or fire. Do not
disassemble or modify batteries.
The insulation inside the battery may be damaged and result
in leakage, heat build-up, or explosion.
• When disposing of the battery insulate the terminal by
wrapping it in tape etc.
(Heating, rupturing, or fire may result if stored together
with other metal objects or batteries)
Observe local waste separation rules when disposing of
button batteries.
• As a guideline, you should replace the battery once a
year. However, the battery should be replaced with a new
battery (CR2025) when signal reception weakens.
• Batteries with an expiration date that is close, may
require replacement sooner.
• The pre-loaded battery is for initial use of the unit. It may
require replacement in less than 1 year.
3
Battery (CR2025)
2 4
Load so that battery + side and side of
+
cover with mark face same direction
Power supply plug
Power socket