Yamaha DRIVE 2 EFI 2020 Owner's/Operator's Manual page 51

MAINTENANCE AND ADJUSTMENT
1. Wire connector
1. Screws (three)
2. Screws (four)
REPLACING A HEADLIGHT UNIT
This model is equipped with LED-type headlights.
If a headlight does not come on, replace it as follows:
1. Disconnect the wire connector from the head-
1
light assembly.
2. Remove the three screws and remove the light
control unit.
3. Remove the four screws to remove the headlight
assembly from the holder.
4. Remove the headlight assembly from the holder.
5. Install new headlight assembly into holder and
secure with the four screws.
6. Install the light control unit and fasten with three
screws.
7. Connect the wire connector to the headlight as-
sembly.
46
1
2
3
4
5
6
7
8
9
10
11
12
13
14