Table of Contents
Advertisement
TL-WA7110ND
Chapter 3.
Quick Installation Guide
This Chapter will guide you to configure the AP to function in your network and gain access to the
internet through your ISP immediately after successful configuration. More detailed description of
the AP's web-based utility and functions can be found in "Chapter 4 Configuring the AP"
3.1
Configure the Device
The
instructions
in
to
be
able
to communicate with the AP.
The default IP address of the TL-WA7110ND 150Mbps High Power Wireless Access
Point is
192.168.0.254. And the default Subnet Mask is 255.255.255.0. These values can be seen from
the
LAN.
They
can
default values for description in this guide.
Connect the local PC to the LAN ports of the AP. There are then two ways to configure the IP
address for your PC.
Configure the IP address manually
1)
Set up the TCP/IP Protocol for your PC. If you need instructions as to how to do this,
please refer to Appendix B: Configuring the PC.
2)
Configure the network parameters. The IP address is 192.168.0.xxx ("xxx" is from 2 to
253), Subnet Mask is 255.255.255.0
Note:
If you configure your device by this way, please remember to change the configuration of your PC
to the figure as shown below to make your PC connect to the Internet successfully.
Obtain an IP address automatically
This method can be available only when DHCP in section 4.8.1 is enabled.
1) Set up the TCP/IP Protocol in "Obtain an IP address automatically" mode on your PC.
If you need instructions as to how to do this, please refer to Appendix B: Configuring the
PC.
150Mbps High Power Wireless Access Point User Guide
this
section
will
help
be
changed
as
you
configure
you
desire,
as
an
10
each
of
your
PCs
example
we
use
the
Advertisement
Table of Contents
