Table of Contents
Advertisement
The terminal assignments for the different network cable wire standards
are as follows:
Network cable wire standard T568A
• Terminal 1: Green wire with white tracer
• Terminal 2: Green wire
• Terminal 3: Orange wire with white tracer
• Terminal 4: Blue wire
• Terminal 5: Blue wire with white tracer
• Terminal 6: Orange wire
• Terminal 7: Brown wire with white tracer
• Terminal 8: Brown wire
Network cable wire standard T568B
• Terminal 1: Orange wire with white tracer
• Terminal 2: Orange wire
• Terminal 3: Green wire with white tracer
• Terminal 4: Blue wire
• Terminal 5: Blue wire with white tracer
• Terminal 6: Green wire
• Terminal 7: Brown wire with white tracer
• Terminal 8: Brown wire
© 2021 Cisco and/or its affiliates. All rights reserved.
CAUTION
RJ45 connectors can be wired according to network cable
wiring standards EIA/TIA T568A or EIA/TIA T568B.
It is strongly recommended that wiring standard T568A
or T568B be chosen at the network design stage, and
applied to all relevant devices throughout the life of the
project.
Always use the same wiring standard at both ends of the
same patch cable (for example, if a cable's RJ45
connector is wired according to T568A, the connector at
the opposite end of the cable must also be wired
according to T568A).
Hardware installation
Page 35 of 177
Advertisement
Table of Contents
