Changing The Operational Mode; Changing The Operational Mode On A Mesh Network-Capable Unit - Cisco FM3500 Endo Installation And Configuration Manual

Figure 23. Configurator GUI (General Mode)
• The GENERAL MODE dialog will be shown

Changing the operational mode

Changing the operational mode on a mesh network-capable unit

The General Mode box (below) contains the operational mode controls.
Fluidmesh radio transceiver units that are capable of operating within a
mesh radio network are shipped from the factory in Mesh End mode.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
(page 63)).
(Figure 23
Page 63 of 177