PSC POWER STAR ELEMENT Operation Manual page 7

6. Once you have determined that you have the unit positioned correctly, you may
carefully drop the unit down over the battery terminals. Please note that the unit
should easily drop down over the terminals without using ANY PRESSURE or FORCE at
all! If you find that it does not easily drop onto the terminals, STOP what you are doing
and re-check the orientation, battery size and type and correct spacing of the Brass
6mm Terminal Adaptors if they are used. DO NOT FORCE THE UNIT ONTO THE BATTERY
AS DAMAGE TO THE UNIT AND/OR BATTERY MAY RESULT. If you have ANY questions,
stop what you are doing and call PSC for help.
7. GENTLY insert the two thumb screws into the holes on the front side of the PowerStar
Element and start threading them in a CLOCKWISE direction (Righty Tighty).
8. Make sure the threads start correctly before continuing to tighten the thumb screws.
Once you are sure that you have correctly started the threads, the screws should easily
thread inward until the RED and BLACK Thumb Screw Caps seat flush to the front edge
of the Power Star Element. You may now fully tighten the thumb screws. The thumb
screws should be fully tightened down with adequate thumb pressure to insure good
electrical contact between the battery contact and the battery terminal. These should
be tightened down fairly tight using your thumb and finger. Tightening using tools is
NOT needed or recommended.