Charger Connector - PSC POWER STAR ELEMENT Operation Manual

CHARGER CONNECTOR:

The PSC Power Star Element is equipped with one 2 pole SpeakOn
connector. This connector is used for the connection of the supplied external battery charger.
Using this connector, you charge the battery that is connected (mounted) to the PSC PowerStar
Element. The polarity of this connector is conventional SpeakOn. The centermost contact is
Positive (+) and the outer ring connection is Negative (-)
SpeakOn "Charger" Connector used for battery charger connection.
CHARGING: The PowerStar Element comes with a supplied battery charger. This charger will
operate world-wide without adjustment as it operates from 100 to 240VAC at either 50Hz or
60Hz. This charger was carefully chosen to charge either Sealed Lead Acid (SLA) batteries or
LiFEPO4 (Lithium Iron Phosphate) batteries. Typical recharge time ranges from 1 to 3 hours. The
charging function is automatic and thus does not require your assistance in any way. Simply plug
the supplied battery charger into the PSC PowerStar Element and the charging begins (when
needed). Be aware that the PowerStar Element Battery Charger may get warm during use. Be
sure to allow ventilation air gaps around the supplied battery charger for proper heat dissipation.
OPTIONAL REMOTE BATTERY CABLE:
We offer an optional cable that allows the Power Star Element to be remotely connected to a
battery. It is our part number FPSECABLE. This cable has machined brass "battery terminals" on
one end and ring terminals on the other end. The cable is normally supplied in a 3' length (0.92
meter) and is constructed from super heavy duty 8AWG wire. This cable will allow you to mount
the Power Star Element in a separate location from your battery and it will allow the unit to be
connected to batteries that do not have standard terminal spacing. The cable comes complete
with a set 6mm screws for use on metric "post less" batteries and also 1/4" bolt and nut for use
on standard terminal batteries.