To Replace The Grill Injector; To Replace The Oven Injector - Kenwood KTG606S19 Installation Instructions Manual

To Replace the Grill Injector

The grill injector can be accessed by removing the single screw
on the tip of the burner (as shown). Remove the screw and pull
the grill burner towards the front of the cooker, the injector will
be revealed on the rear surface of the cavity.
Remove the injector with a 7mm spanner and replace the
injector with the ones from the spare set, with corresponding
diameters suitable to the type of gas that is going to be used,
according to the information chart (which is also supplied in the
gas conversion kit).

To Replace the Oven Injector

The oven burner is fixed in its cradle by a single clip
that is placed on the left-hand side of the burner. Pull
the clip further left, and with your other hand, lift
the burner up holding from the thermocouple/spark
plug holder.
The injector is placed on the right side of the burner
cradle.
Remove the injector with a 7mm spanner and
replace the injector with the ones from the spare
set, with corresponding diameters suitable to the
type of gas that is going to be used, according to the
information chart (which is also supplied in
the gas conversion kit).
* All images are for indication only; please refer to your individual unit for actual item.
36
Kenwood Free Standing Twin Cavity Gas Cooker KTG606S19 Manual.indd 36 Kenwood Free Standing Twin Cavity Gas Cooker KTG606S19 Manual.indd 36
Screw
Injector
Clip
15/01/2021 15:59 15/01/2021 15:59