First Time Use Of The Oven; Oven Control; Lighting The Oven Burner - Kenwood KTG606S19 Installation Instructions Manual

First Time Use of the Oven

Ensure that nothing has been left in the oven. Remove any insert cards or plastic bags. Before connecting the
power, use a damp cloth to carefully wipe the inner cavity wall and housing. Clean all the detachable parts in hot,
soapy water before using.
Heat the oven on maximum for 45 minutes. (Please refer to the "Lighting the Oven Burner" section) There may
be a little smoke and odour upon initial start up (for about 15 mins). This is normal. It is due to the protective
substance which protects the cooker from the effects of corrosion during shipping from the factory.

Oven Control

This controls the oven burner.
Turn the control anti-clockwise and set to the relevant setting needed.

Lighting the Oven Burner

1. Press the oven control and turn counter-clockwise so that the control is at the maximum position. Continue
pressing the control until the burner has lit, continue holding the control in for approximately 5 to 10
seconds after the burner has lit. Releasing the control too soon will extinguish the flame due to the flame
failure safety feature.
Manual Ignition (in case of electricity failure)
To ignite the oven burner, press and turn the control counter-clockwise so that the control is at its maximum
position. Hold an ignition source (e.g. candle lighter) close to the upper circumference of the burner.
Move the ignition source away as soon as you see a stable flame. Continue holding the control in for
approximately 5 to 10 seconds after the burner has lit. Releasing the control too soon will extinguish the
flame due to the flame failure safety feature.
2. After ignition, check the flames visually. If you see yellow tipped, lifted or unstable flames; turn the control
off. If the burner flames go out accidentally, turn the burner off, open the door and do not try to light it
again for at least 1 minute (to allow the gas to disperse).
3. When turning the oven off, turn the control in a clockwise direction so that the control shows
0 (OFF) position in line with the marking on the control panel.
• If the burner does not light within 15 seconds, turn the control off and wait for at least one minute
before trying again.
• To switch the burner off, turn the control clockwise to the 0 position.
• After use, always turn the controls to the 0 position.
This appliance is for cooking purposes only. It must not be used for other purposes, for example
room heating.
* All images are for indication only; please refer to your individual unit for actual item.
Kenwood Free Standing Twin Cavity Gas Cooker KTG606S19 Manual.indd 15 Kenwood Free Standing Twin Cavity Gas Cooker KTG606S19 Manual.indd 15
15
15/01/2021 15:59 15/01/2021 15:59