If The Burner Does Not Light; If The Flame Is Irregular; Using The Hob - Kenwood KTG606S19 Installation Instructions Manual

If the Burner Does Not Light

If the burner does not light, check that:
• The cooker is switched on at the mains supply to enable the ignition circuit to work.
• The gas is turned on.
• You have held in the control for at least 5 to 10 seconds.
• The ignitors are sparking. If the ignitors are not sparking, they may be dirty or wet. Clean them gently
with a small nylon brush such as a toothbrush as shown below.
Never operate the ignition without the burner parts in position. You may damage the electric
ignition.
Ignitor

If the Flame Is Irregular

If the flame is yellow or irregular, check that the burner parts, including the burner cap, are:
• Clean and dry.
• Positioned correctly. See 'Replacing the Burners' .
• Also see 'Hints and Tips' .

Using the Hob

The control has 3 positions: 0, maximum (
maximum position (
minimum ( ) flame positions. You must not cook with the control between the maximum (
* All images are for indication only; please refer to your individual unit for actual item.
Kenwood Free Standing Twin Cavity Gas Cooker KTG606S19 Manual.indd 13 Kenwood Free Standing Twin Cavity Gas Cooker KTG606S19 Manual.indd 13
) and minimum (
), you should adjust the flame length for cooking between the maximum (
Flame failure probe
). After you have ignited the burner at the
) and
) and 0 positions.
13
15/01/2021 15:59 15/01/2021 15:59