Can-Bus Coupler Pws-C - Electro-Voice PWS-4 Owner's Manual

PROGRAMMABLE WALL STATION

2 CAN-Bus coupler PWS-C

The CAN-Bus coupler PWS-C provides connection between front units (e.g. PWS-4) and the CAN-Bus.
The CAN-Bus coupler registers the activation of controls on the connected front units and sends the
needed information via CAN-Bus to the devices to be controlled, but also directs information received from
the CAN-Bus to the control units for indication. The CAN-Bus coupler offers connectors for CAN-Bus and
power supply as well as DIP switches for the CAN-Bus configuration (baud rate, bus termination and CAN-
Bus address). The CAN-Bus coupler PWS-C is suitable for European and US-type flush-mount boxes.
Front view:
2
Rear view:
4
3
Default settings:
Parameter
Baud rate
Termination
CAN-Bus address
6 Owner's manual
1 Connector for the front unit
2 Connector for future extensions
1
1 DIP switch TERM/BAUD for setting baud rate and termination of
the CAN-Bus (see page 11)
2 DIP switch ADDRESS for setting the CAN-address (see page 14)
3 CAN Status-LED for monitoring communication on the CAN-Bus
1
4 Terminal for CAN-Bus and supply voltage (see page 15)
2
PROG mode (10 kbaud, changeable via IRIS-Net™)
off
00 (CAN-Bus off, Stand-alone)
Value