Setting Up The Circuit; Configuring The Netgear Fwg114P - ADTRAN Express 3000 Quick Start Manual

Hide thumbs Also See for Express 3000:

Table of Contents

Setting up the circuit

1. Unplug the serial cable from the COM port of the PC and plug that end into the

Modem connection on the Netgear FWG114P. The serial cable should now be

connecting the Netgear FWG114P router with the ADTRAN Express 3000.

2. Use the Ethernet cable provided with the Netgear FWG114P to connect one of the

local ports on the Netgear FWG114P to the Network card on your PC.

3. Power on the Netgear FWG114P by plugging in the power cord and restart your

computer.

NOTE: The steps that follow may differ depending on the firmware version loaded on the

Netgear.

1. Open your web browser (Internet Explorer, Mozilla Firefox, etc.).

2. In the address bar type

Netgear router). If you are unable to connect, restart the Netgear FWG114P by

cycling the power.

3. You will be asked for a username and password, and by default they are "admin"

and "password", respectively.

Network Diagram

http://192.168.0.1

(this is the built in web page for the

Table of Contents

Do you have a question about the Express 3000 and is the answer not in the manual?