Table of Contents
Advertisement
Available languages
Available languages
BEFORE USING YOUR PORTABLE WASHER
·
Remove the exterior and interior packing.
·
You will need the following tools:
·
Wrench
·
Pliers
·
Screwdriver
·
Check to be sure you have all of the following parts:
·
2 Inlet Hose
·
2 Faucet Adapters
·
1 Water Inlet Cover
·
1 Drain Hose Assembly (Pre-Installed)
·
Remove shipping brace. Note - It should be saved and used (to prevent damage to washer
components) whenever washer is moved or transported to a new location.
·
Clean the interior surface with lukewarm water using a soft cloth.
·
Allow 2 inches of space between the back and sides of the appliance.
·
Put your laundry into the washer evenly. Uneven laundry may cause noise or vibration.
·
DO NOT use excessively hot water (122ºF / 50°C or more). Plastic parts may be deformed or
damaged. Also, clothing may be deformed or bleached.
·
Before washing, check all pockets. If nails or pins remain in pockets, they may damage the
washer or clothes.
·
Never splash water on the control panel.
·
Plug the washer into an exclusive properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
Authorized Avanti Products service center.
SELECTING A LOCATION
Before you install the portable washer, select a location with the following
characteristics:
·
A hard level surface (if the surface is uneven, see Adjusting The
Adjustable Foot section on the next page).
·
Away from direct sunlight. Direct sunlight may affect the acrylic coating,
plastic and electrical components.
·
Adequate ventilation.
·
Away from sources of heat such as coal or gas. Make sure that the
washing machine does not stand on its power cord.
·
Ventilation openings must not be obstructed by carpeting when the
portable washer is installed on a carpeted floor.
·
It is recommended that you place your portable washer on a hard material
floor such as tile, concrete, linoleum and to avoid if at all possible,
placement on wooden floors or carpeted areas.
INSTALLATION INSTRUCTIONS
8
SCREWDRIVER
PLIERS
WRENCH
Advertisement
Table of Contents
