Adjustable extension compression seal roof drain and threaded seal roof drain (10 pages)
Summary of Contents for Watts AERCO AquaSolve AM8408-COM
Page 1
Operation & Maintenance Manual AquaSolve ® Anti-Scale Systems Chemical-Free, Salt-Free Scale Prevention AM8408-COM (12 GPM) AM8410-COM (20 GPM) Important: Read this Manual BEFORE using this equipment. Failure to read and follow all safety and use information can result in death, serious personal injury, property damage, or damage to the equipment.
Page 2
Operation & Maintenance Manual AquaSolve ® INTRODUCTION • Compatible with all on-site and community wastewater treatment systems The AquaSolve Anti-Scale System provides pro- • Perfect system for towns or communities where tection from scale formation on internal plumbing water softeners are banned or restricted surfaces.
Page 3
Operation & Maintenance Manual AquaSolve ® Specifications NOTICE Spotting May Occur on External Plumbing Surfaces. AquaSolve scale prevention system shall be installed AquaSolve media systems perform best in single pass pota- on the main water service pipe just after it enters the ble water applications with NO additional chemical additives.
Page 4
Operation & Maintenance Manual AquaSolve ® Equipment Specifications *****All other contaminants must meet the requirements of the USEPA Safe Drinking Water Act. Specific Mineral and Metal MCL’s, identified in AERCO published Feed Water Chemistry Requirements, supersedes AquaSolve systems are complete, selfcontained, the USEPA SDWA.
Page 5
Operation & Maintenance Manual AquaSolve ® Replacement Media NOTICE • We recommend the installation of a dual-union ball-valve on Model Part # Frequency the inlet and outlet to isolate the tank for servicing. Media should be replaced every • A full bypass should be installed so that the full service flow AM8408-COM-RM 144903 3 years...
Page 6
Operation & Maintenance Manual AquaSolve ® By-Pass Valve AquaSolve Treated Water AquaSolve Untreated Water 4. Connect the cold water supply to the inlet of the AquaSolve system. Install an inlet water supply Installation and Start-Up valve (user supplied) in this line and close it. NOTE: The AquaSolve system operates in the UP-FLOW mode which is opposite of a conventional softener.
Page 7
Operation & Maintenance Manual AquaSolve ® about half full with water. NOTICE 12. Reinstall the distributer tube with bottom strainer Your AquaSolve media should be replaced every 3 years. Dispose of old media and/or container in accordance with local, regional, that was removed in step 6.
Page 8
Operation & Maintenance Manual AquaSolve ® Alternative Method for Replacing Media from date of original installation. Such replacement media will be deliv- ered to the owner F.O.B. nearest factory, at no cost, excluding freight and local labor charges, if any. Damage to the media due to chlorine, Follow steps 1 –...
Need help?
Do you have a question about the AERCO AquaSolve AM8408-COM and is the answer not in the manual?
Questions and answers